Summary
rbp is the base pointer, which points to the base of the current stack frame, and %rsp is the stack pointer, which points to the top of the current stack frame. %rbp always has a higher value than %rsp because the stack starts at a high memory address and grows downwards.
1
2
According to
Summary
%rbp is the base pointer, which points to the base of the current stack frame, and %rsp is the stack pointer, which points to the top of the current stack frame. %rbp always has a higher value than %rsp because the stack starts at a high memory address and grows downwards.
Understanding C by learning assembly - Blog - Recurse Center
recurse.com
Sets up a procedure’s stack frame by first pushing the current value of %rbp on to the stack, storing the current value of %rsp in %rbp , and finally ...
X86-64 Architecture Guide
mit.edu
However, you MUST put rsp back where you found it, as well as rbp, rbx, and r12-r15. For example, "rbp" is a preserved register, so you need to save its value ...
CS 301 Lecture
uaf.edu
Unable to generate a short snippet for this page, sorry about that.
brown.edu
There are also three registers that are important at this point - RBP, RSP, and RIP. RSP is the stack pointer. The stack works just like a LIFO queue with ...
Buffer Overflows and You
turkeyland.net
Sets up a procedure’s stack frame by first pushing the current value of %rbp on to the stack, storing the current value of %rsp in %rbp , and finally ...
X86-64 Architecture Guide
mit.edu
